HP 18-1200 Podręcznik dla początkujących - Strona 19
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Pulpit HP 18-1200. HP 18-1200 25 stron. Quick setup guide
Również dla HP 18-1200: Szybki start (1 strony), Podręcznik (13 strony), Podręcznik szybkiej konfiguracji (21 strony)
Keyboard and mouse (wireless)
Symptom
Wireless keyboard
or mouse does not
work or is not
detected.
ENWW
Possible solution
Ensure that you are using the wireless keyboard or wireless mouse within range of the
●
receiver, approximately 10 meters (32 feet) for normal use, and within 30 cm (12
inches) during initial setup or for re-synchronization.
Ensure that the mouse is not in Suspend mode, which occurs after 20 minutes of
●
inactivity. Click the left mouse button to reactivate it.
Replace the batteries in the keyboard and mouse.
●
Re-synchronize the keyboard and mouse to the receiver using the following steps.
●
The receiver, wireless keyboard, and wireless mouse shown in the following illustrations
are examples; your models might vary. IMPORTANT: During these steps, place the
wireless keyboard and wireless mouse on the same level as the receiver, within 30 cm (12
inches) of the receiver, and away from interference from other devices.
1.
Unplug the receiver from a USB connector on the computer, and then reconnect it.
Your computer model might have a connector dedicated to the receiver. If you have a
choice, use a USB connector on the front of the computer.
2.
Check that the mouse is on (A), and push and hold the Connect button (B) on the
underside of the mouse for 5 to 10 seconds until the LED on the receiver lights or
stops flashing. The receiver connection session times out after 60 seconds. To ensure
that the connection was established, and that the receiver did not time out instead,
move the mouse and check for response on the screen.
B
A
Off
Connect
On
3.
After the mouse connection is established, continue by using the steps that follow to
repeat the procedure for the keyboard.
4.
Push and hold the Connect button (C) on the underside of the keyboard for 5 to 10
seconds until the LED on the receiver lights or stops flashing.
C
Keyboard and mouse (wireless)
13