Miele T 6751 Instrukcja obsługi - Strona 24

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Suszarka Miele T 6751. Miele T 6751 26 stron. Tumble dryers
Również dla Miele T 6751: Instrukcja obsługi (32 strony), Instrukcja obsługi (28 strony)

Drukuj stronę

Notes for the installer

Steam connection

The steam connection must only be under-

taken by an authorized installer.

Please pay attention to the installation dia-

gram and instructions supplied with the ma-

chine. These are important for the connection

to steam.

All removable outer housing parts must be re-

fitted after the steam connection has been

made.

Important notes for the heat exchanger

To avoid damage to the heat exchanger the

following must be observed during commis-

sioning:

1. To avoid unecessary heat tension ensure

that heating up is even (no sudden bursts of

steam).

2. To prevent corrosion the intake water must

be treated. It is particularly important during

idle periods to ensure that air (oxygen and

) cannot get into the heat exchanger.

The condensate drain must be installed in

such a manner that the heat exchanger can

empty fully when it is not in use. There must

be no condensation at all left in it.

3. The heat exchanger must be protected from

aggressive gases on the side exposed to

the air.

4. Ensure that the heat exchanger does not

operate at a higher operating pressure or

temperature than is stated on the data plate.

5. Pay heed to all current local and national

guidelines, standards and regulations relat-

ing to the installation, operation and mainte-

nance of heating and ventilation systems,

with particular regard to the use of heat ex-

changers.

Gas connection

The gas connection may only be carried out

by a suitably qualified (e.g. Corgi registered)

engineer, in accordance with local and na-

tional safety regulations. The enclosed instal-

lation diagram and the installation instructions

for gas must be followed to ensure correct gas

connection.

Please pay attention to the installation dia-

gram and instructions supplied with the ma-

chine. These are important for the connection

to gas.

The gas group to which the machines have

been set at the factory is given on the Gas

Data sticker affixed to the rear of the machine.

When converting to another gas group, or to

liquid gas, a conversion kit is required, avail-

able from the Spare Parts department, (give

the model and serial number of the machine

as well as the gas type, group and connection

pressure in the country of installation when or-

dering). The installation instructions for gas

heated machines must be followed. Conver-

sion may only be carried out by suitable com-

petent persons.

All removable outer housing parts must be re-

fitted after the gas connection has been made.

Do not attempt to undertake any repairs to gas

heated machines yourself. Repairs must only

be carried out by suitably competent persons

to ensure safety, e.g. gas engineers must be

registered. Please consult the Miele Cus-

tomer Service department or an authorized

Service dealer.

«M.-Nr.04989220/02 - GB - »