HP 3000 Series Instrukcja aktualizacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja aktualizacji dla Pulpit HP 3000 Series. HP 3000 Series 19 stron. 9x9 to k class conversion
Również dla HP 3000 Series: Podręcznik (25 strony), Podręcznik (20 strony), Instrukcja instalacji (42 strony)

Drukuj stronę

CPU Upgrade

Adding a CPU Card

NOTE

If there are more CPUs to add, proceed to the appropriate Adding a CPU Card

procedures. If there are no more CPUs to add, proceed to Installation Verification.

Adding CPUs #2 - 3

Before removing the back cover and starting the installation procedures, position the computer to allow

enough room to work behind it. Be careful doing this, however, because you may stretch, crimp, or

disconnect cables attached to the back of the computer. Be sure that you have performed the procedures

in the Adding a CPU Card section before beginning additional CPU installation.

Adding CPUs #2-3 to an HP3000/959KS, 969KS and HP9000/Kx00/Kx20

1. Remove the sheet metal case.

2. Identify the next available CPU slot in sequence. Carefully reach into the computer cabinet and

remove the CPU connector dust cover by grasping the extended tab and pulling it out.

3. Remove the protective dust cover from the CPU card and carefully align the CPU card into the

appropriate slot. Be sure the air guide and card components are on the right-hand side of the card

during installation.

4. Insert the CPU card until it contacts the system board connector, then press firmly to seat the card.

NOTE

If there are more CPUs to add, proceed to the appropriate Adding a CPU Card

instructions. If there are no more CPUs to add, proceed to Installation Verification.

5. Replace the back CPU cover plate and tighten the two captive mounting screws.

At this point, refer to the Installation Verification section to determine how to make sure that the

computer has configured the new CPU(s).