Miele S 2110 Informacje techniczne - Strona 33

Przeglądaj online lub pobierz pdf Informacje techniczne dla Odkurzacz Miele S 2110. Miele S 2110 34 stron. Vacuum cleaners
Również dla Miele S 2110: Broszura (12 strony), Instrukcja obsługi (48 strony), Instrukcja obsługi (24 strony)

Miele S 2110 Informacje techniczne
S2 Canister Vacuums
Note:
The motor protection filter should always be changed when a new pack of
Miele vacuum bags is opened. A motor protection filter is supplied with every
pack of Miele vacuum bags.
Cause:
Exhaust filter clogged.
Remedy:
Replace the exhaust filter.
Note:
1. Super Air Clean
This exhaust filter should always be changed when a new pack of Miele
vacuum bags is opened. A Super Air Clean exhaust filter is supplied with
every pack of Miele vacuum bags.
2. Active Air Clean - Active HEPA
This exhaust filter must be changed after approximately 1 year. The date
can be written on the filter.
4

Service

4.1

Telescopic Suction Hose Locking Piece Replacement

1. Release the old locking piece with a small flathead screwdriver.
2. Remove the cap (Figure 040-2, Item A). The pushbutton and spring
underneath will be released as well.
3.
The insert (Figure 040-2, Item B) will also come out when the locking
piece is removed.

Figure 040-2: Telescopic Locking Piece

Note:
When re-installing, carry out the following in the given order:
1. Install the pushbutton, Figure 040-2, Item A.
2. Press and hold the pushbutton while sliding the insert (Figure 040-2, Item
B) into the suction hose.
The insert can be replaced separately, if needed.
33
Technical Information