Miele Triflex HX1 Cat&Dog SMML0 Instrukcja obsługi - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odkurzacz Miele Triflex HX1 Cat&Dog SMML0. Miele Triflex HX1 Cat&Dog SMML0 38 stron. Cordless stick vacuum cleaner
Również dla Miele Triflex HX1 Cat&Dog SMML0: Instrukcja obsługi (40 strony)
Drukuj stronę
Charging the battery (with wall
mounting) (Figs. 12 + 13)
There are 2 ways to store and charge
the vacuum cleaner in the supplied wall
bracket.
You will need a suitable location near
a free electrical outlet for mounting the
appliance on the wall.
Wall mounting (Figs. 14 + 15)
The supplied wall bracket has a mount-
ing plate with a bag of screws attached
to the back.
Attach the mounting plate to the point
on the wall where you want the wall
mounting to be.
Remove the bag of screws.
Press the release catch at the bottom
of the wall bracket.
Remove the mounting plate from the
wall bracket by sliding it downwards.
Attaching the mounting plate
(Figs. 16 + 17)
2 plugs and 2 T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need an electric screw-
driver or a drill (with a 1/4" drill bit).
Depending on how your vacuum
cleaner is configured, select a distance
of 17 3/4" or 38 1/2" (45 cm or 98 cm)
between the bottom edge of the mount-
ing plate and the floor.
Be careful not to damage any electri-
cal in the wall.
Attach the mounting plate to the wall.
Attaching the charging cable to the
wall bracket (Figs. 18, 19 + 20)
A cable compartment is located on the
underside of the wall bracket.
Press both release catches on the un-
derside of the wall bracket and re-
move the cable compartment cover.
Plug the supplied charging cable into
the opening from above.
Lay the charging cable in its guide.
Refit the cover and close the cable
compartment.
Connecting the accessories holder
(if required) (Fig. 21)
An accessories holder is supplied for
storing the three-piece accessory set
(see "Using the accessories supplied").
Push the accessories holder on to the
wall bracket as far as it will go.
Connecting the wall bracket
(Figs. 22 + 23)
Slide the wall bracket down into the
mounting plate from above until it au-
dibly clicks into place.
Slide the PowerUnit of the fully as-
sembled vacuum cleaner, with the
battery inserted, down into the wall
bracket from above.
Plug the charger into the power
socket.
The charging process will start.
Battery charging state indicator
(while charging) (Fig. 24)
The battery charging state is displayed
on the PowerUnit.
en-US
19