Bürkert 8020 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Bürkert 8020. Bürkert 8020 10 stron. Flowmeter with paddle wheel

Drukuj stronę
DANGER
Risk of injury due to electrical voltage.
▶ Shut down and isolate the electrical power source before
carrying out work on the system.
▶ Observe all applicable accident protection and safety
regulations for electrical equipment.
WARNING
Risk of injury due to non-conforming installation.
▶ The electrical and fluid installation can only be carried out
by qualified and skilled staff with the appropriate tools.
▶ Observe mounting instructions of the fitting.
▶ Risk of injury due to an uncontrolled restart.
▶ Ensure that the restart of the installation is controlled
after any interventions on it.
English
20
NOTE
Risk of damage to the device due to the environment
▶ Protect this device against electromagnetic interference,
ultraviolet rays and, when installed outdoors, the effects
of the climatic conditions.
To make sure the device operates correctly, plug in
and tighten the connector.
Installation of the fitting onto the
pipe
→
Choose a fitting appropriate to the velocity and the flow
rate of the fluid inside the pipe, refer to the graphs at right
(see Table 2). The graph is used to determine the DN of
the pipe and the fitting appropriate to the application,
according to the fluid velocity and the flow rate.
→
Install the fitting on the pipe as described in the operating
instructions of the fitting used.
English
22
WARNING
Risk of injury if the fluid pressure/ temperature
dependency is not respected.
▶ Take account of fluid temperature-pressure dependency
according to the nature of the materials the fitting is made
of (see Table 1).
▶ Comply with the pressure equipment directive 2014/68/EU.
WARNING
Risk of injury due to non-conforming commissioning.
Non-conforming commissioning may lead to injuries and
damage the device and its surroundings.
▶ Before commissioning, make sure that the staff in
charge have read and fully understood the contents of
the manual.
▶ In particular, observe the safety recommendations and
intended use.
▶ The device / the installation must only be commissioned
by suitably trained staff.
Flow rate
US gpm
3
l/min
m
/h
100000
20000
5000
50000
10000
2000
30000
20000
5000
1000
10000
500
2000
5000
1000
200
3000
2000
500
100
1000
50
200
500
100
20
200
50
10
100
5
20
50
10
2
20
5
1
10
0.5
2
5
1
0.2
2
0.5
0.1
1
0.05
0.2
0.5
0.1
0.02
0.2
0.05
0.01
0.1
0.3 0.5 1
0.3 0.5
1
Table 2:  Diagram flow rate / fluid velocity / DN of the 
fittings type S020
English
DN 400
DN 350
DN 300
DN 250
DN 200
DN 150
DN 125
DN 100
DN 80
DN 65
DN 50 (DN65)*
DN 40 (DN50)*
DN 32 (DN40)*
DN 25 (DN32)*
DN 20 (DN25)*
1)
Example
3 5
10
m/s
3 5 10
30
fps
Fluid velocity
English
21
21
23
23