ALLNIC AUDIO H-6500 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz ALLNIC AUDIO H-6500. ALLNIC AUDIO H-6500 16 stron. Phono-stage preamplifier

POWER CONNECTIONS

The H-6500 power supply uses a standard three prong male IEC connection for AC input

(See Figure 1), located on the right-hand side of the rear of the power supply (facing the

rear). You need to use a power cord with a female three prong IEC connector at one end.

The H-6500 power supply connects to the phono-stage itself using the supplied umbilical

cable. Connect the units to each other using the provided umbilical cable, with the

appropriate screw-on connections to the receptacle labeled "DC Source Input" on the

rear of the phono-stage and the connection terminal labeled "DC Source Output" on the

left side of the rear of the power supply (See Figure 1).

The H-6500 power supply you have purchased is set internally for your region, either

AC 230/240 volt – 60 HZ OR AC 110/120 volt – 60Hz operation for USA, Canada.

There is no way to change this to another AC setting.

There are two (2) sets of two (2) pairs of single-ended (RCA) inputs (See Figure 2). These

two pairs are located on the left-hand side of the rear of the phono-stage (facing the

rear - See Figure 1). Each channel pair of inputs is aligned vertically, with the left channel

input at the top and the right channel input on the bottom. The two left hand pair of

inputs (facing the back of the phono-stage) have an "MC" label above the two upper,

i.e. the left, channel connectors; these are the two input pairs for moving coil cartridges.

The two right-hand pairs of inputs have an "MM" label above the left channel

connectors; these are the two input pairs for moving magnet cartridges.

In each case, for both MC and MM connections the left hand vertically aligned pair of

connections (again, facing the back of the unit) corresponds to input 1 for the button

switch on the front panel of the phono-stage, while the right hand vertically aligned pair

is input 2.

To the left of the four MC RCA input connections is a screw type connector. This

connector is the ground connection for a ground wire from a cartridge and/or turntable

if you are using a moving coil cartridge. To the right of the four MM RCA input

connections is another screw type connector. This connector is the ground connection

for a ground wire from a cartridge and/or turntable if you are using a moving magnet

cartridge (See Figure 2).

When you are facing the front of the H-6500, the two pairs of MC connections are on the

far right of the unit, with the two MM connections immediately to their left.

The H-6500 has been designed and manufactured to work most synergistically with Allnic

Audio active phono preamplifiers, line stages, amplifiers and ZL cables.