ALLNIC AUDIO L-10000 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz ALLNIC AUDIO L-10000. ALLNIC AUDIO L-10000 17 stron. Otl/ocl line-stage preamplifier

Drukuj stronę

gain stages are set up and functioning properly, the needles of the meters should be in the centre

between the two parallel lines in the middle of the meters.

These illuminated meters perform two functions:

First, the meters are used to balance the outputs of the third gain stage tubes for the right

•

and left channels, as explained above in "Initial Set-up". Remember, when replacing the

300B tubes be sure to turn the screw for each meter so the needle is on or just below the

left-hand parallel line on the meter's face.

and insert tubes.

•

Second, the meters are indicators of failure or damage to the function of the unit. Any failure

of the tubes or circuits in one or the other of the L-10000 OTL/OCL's channels is indicated by

the needle on the meter for the respective channel moving out from between those two

parallel lines.

If the needle has moved to the left of the parallel lines on either meter, it means that

•

one or both of the third gain stage tubs (300B) for that channel is failing.

•

If the needle on either meter moves to the right of the parallel lines, it means that one

or both of the first and second gain stage tubes (6AN8 or 12AU7) for that channel is

failing.

In the case of any failure indicated by the meter, please contact Allnic Audio or its authorized

representative for assistance.

TUBES

The L-10000 OTL/OCL uses the following tubes (see Figure 5):

•

Two (2) x 6AN8

•

Two (2) x 12AU7

Four (4) x 300B

•

All consequences of changing or attempting to change tubes are borne by the user unless by

express agreement between the owner and Allnic Audio or its authorized representative. Allnic

Audio and its authorized representatives are not liable in any way whatsoever for any injury or

loss incurred by the user or for damage to the L-10000 OTL/OCL, any of its parts, or tubes or

replacement tubes resulting from the user changing or attempting to change tubes.

The L-10000 must be powered off to remove