ALLNIC AUDIO M-2500 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz ALLNIC AUDIO M-2500. ALLNIC AUDIO M-2500 16 stron. Px25/300b/kt150 push-pull monoblock power amplifiers

Drukuj stronę
ALLNIC AUDIO M-2500 Instrukcja obsługi
Note:
1)
The M-2500s ship with the tubes installed.
2)
The M-2500s will work with most 15 amp, IEC type aftermarket power cords. The Allnic ZL-
3000 and ZL-5000 power cables will make an excellent match. Of course, only you can
determine the power cord that works most synergistically with the M-2500s in your system.
3)
Be sure the M-2500s are labeled for the AC voltage of your location. If they are not, DO NOT
connect them to your AC outlet. Please contact your Allnic dealer.
We advise that you keep the boxes and other packing materials that your M-2500s came in. It will be
useful if you sell your M-2500s or in the unlikely event you need to ship it for service.

SAFETY

• Remove ALL protective cushioning material (cardboard around the tubes) inside the tube
chimneys before operation. The tube chimneys should contain NOTHING except the tubes
(It is optional to leave the "O" rings on the small tubes; some prefer the sound with the O
rings on).
• Disconnect the power cord by pulling the plug, not the cable.
• Do not attempt any repairs. Do not remove the unit's chassis cover without specific
authorization from your Allnic dealer.
• Keep the power cord away from heat sources
• Keep the unit away from liquids – do not allow any liquid to enter the interior of the unit.

CLEANING

A.
Chassis and glass
Use only a soft, lint-free cloth, dampened slightly with water only (NO cleaning fluids!), to clean the
faceplate, chassis and tube chimneys of the M-2500s.
B.

Connectors

You may use any good quality contact cleaner recommended for such applications to clean the contacts
from time to time, as you deem appropriate.

INITIAL SET-UP

A.

LOCATION, LOCATION, LOCATION

Like all audio products using tubes, the Allnic Audio M-2500s need to be placed on a solid stand in a
location that provides good air circulation around, above and below the monoblocks.
• DO NOT cover the tops of the M-2500s.
• DO NOT place the M-2500s on carpet or foam.
6