Dialog DA16200 Podręcznik użytkownika - Strona 17

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt komputerowy Dialog DA16200. Dialog DA16200 20 stron. At gui tool

Drukuj stronę

DA16200 AT GUI Tool

Regulatory Approval

4.1

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the following measures:

●

Reorient or relocate the receiving antenna.

●

Increase the separation between the equipment and receiver.

●

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

●

Consult the dealer or an experienced radio/TV technician for help.

4.1.1

FCC Caution:

Any changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

4.1.2

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This transmitter module must not be co-located or operating in conjunction with any

other antenna or transmitter.

The module must be installed in WiFi Module.

This End equipment should be installed and operated with a minimum distance of 20cm between the

radiator and your body.

IMPORTANT NOTE:

In the event that these conditions can not be met (for example certain laptop configurations or co-

location with another transmitter), then the FCC authorization is no longer considered valid and the

FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be

responsible for re-evaluating the end product (including the transmitter) and obtaining a separate

FCC authorization.

4.1.3

End Product Labeling

The final end product must be labelled in a visible area with the following:

"Contains FCC ID: 2AU49-DA16200MC", or "Contains FCC ID: 2AU49-DA16200ME"

User Manual

CFR0012

Revision 1.0 DRAFT

17 of 20

03-Jul-2019