AllPondSolutions 800-HO+ Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Systemy filtracji wody AllPondSolutions 800-HO+. AllPondSolutions 800-HO+ 17 stron. Aquarium hang-on filter with uv

Drukuj stronę

ELECTRIC

This unit comes complete with a generous supply of 3 core cable, however

should any additional cable be required, the use of an approved waterproof

cable connector with a proper rating is essential. A cord rated for less amperes

or watts than the appliance rating may overheat.

Please Ensure:

The power supply must be earthed and fused at 3amps.

You regularly inspect the cable for damage and deterioration.

Do not connect to any voltage other than that stated.

You consult a qualiﬁed electrician if in doubt about any aspects of

wiring.

Important: The power supply must be earthed and fused at 3amps. Regularly

inspect the cable for damage and deterioration. Consult a qualiﬁed electrician if

in doubt about any aspects of wiring.

INSTALLATION & USE

Please read the below instructions carefully before beginning to set up your

ﬁlter. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS

COMPLETE AND UNIT IS FILLED WITH WATER.

Important installation information:

When installing your ﬁlter, the minimum water level in the tank should be

no more than 6 cm (2.25 inches) below the aquarium rim.

The inlet pipe should NOT be positioned too close to an air stone, aeration

device or the output valve to avoid reducing the eﬀectiveness of the ﬁlter.

Firstly, unpack the unit and identify all parts using the parts diagram in this

instruction manual.