AllPondSolutions AqueECO 14000 Podręcznik - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik dla Pompy do oczek wodnych AllPondSolutions AqueECO 14000. AllPondSolutions AqueECO 14000 14 stron.
INSTALLATION & USE
The All Pond Solutions AquaEco pump range can be used to circulate water or
to pump to and from a separate filtration system or water features using
suitable flexible hose (flexible hosing sold separately). It can only be used with
freshwater and tropical set ups.
Please read the below instructions carefully before beginning to set up your
pump. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS
COMPLETE AND UNIT IS FILLED WITH WATER.
1. Connect the required attachments - start off by attaching the adaptor to the
unit. You can then attach the rest of the parts in this order: hosetail o-ring,
hosetail, hosetail nut.
Inlet hose - if an inlet hosetail is required, you can
follow the above instructions to assemble it after you
remove the inlet guard (see image on the right).
2. Position the pump - fully submerge your
AquaECO unit. Place it on a level and sturdy surface
at the bottom of your pond, this is to avoid silt
entering the pump causing excessive wear and
increasing filter cage cleaning.
3. Connect your AquaECO pump to the mains - Connect the unit to the mains
using a residual current device (RCD) for additional safety.
4. Switch on your unit at the mains - turn on the operation by switching on
the unit at the mains.