ALLPOWER EPW1600 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Myjka ciśnieniowa ALLPOWER EPW1600. ALLPOWER EPW1600 20 stron. Electric pressure washer

TROUBLESHOOTING |

TROUBLESHOOTING GUIDE

The following troubleshooting guide is recommended for basic or

common problems; if there's an issue with the generator that is not

listed, please call 1-888-896-6881.

Problem

When the switch is in the "I"

position the machine will not

start.

The pump does not reach

adequate pressure or

fluctuates.

The pressure washer has or

will not maintain pressure.

14 | ALL POWER™ EPW1600 POWER WASHER

OWNER'S MANUAL

Probable Cause

Electrical socket is faulty.

Voltage is inadequate.

GFCI trips.

Power cord is not plugged in.

Water Intake Filter is clogged

Pump is drawing air

Suction valves are clogged/worn

Diameter of garden hose too small

Water supply is restricted

Insufficient water supply

Excessive air in waterline and pump

NOTE: Troubleshooting problems may have similar causes

and solutions.

Solution

Check plug, socket and fuses.

Check that the voltage is adequate.

Reset/Try another outlet.

Plug in power cord.

Remove and clean filter

Tighten connections/bleed system

Clean or replace valves

Replace with ¾ inch garden hose

Check hose for kinks or leaks

Fully open water source

Turn unit and water supply off / Bleed system / Hold trigger down