Miller 028042104 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller 028042104. Miller 028042104 20 stron.
Również dla Miller 028042104: Instrukcja obsługi (20 strony)

Drukuj stronę
Miller 028042104 Instrukcja obsługi
SECTION 6 − MAINTENANCE & TROUBLESHOOTING

6-1. Routine Maintenance

n = Check
* To be done by Factory Authorized Service Agent
Every
~
3
Months
tions may require more frequent cleaning
(continuous use, high/low temperatures,
dirty environment, etc.). Failure to properly
clean coolant strainer voids pump warranty.
Every
6
Months
nlHoses
Every
Change
12
Coolant (If
Months
Using Miller
Coolant)
ZReplace coolant.

6-2. Coolant Maintenance

!
Disconnect cooler plug from welding power source receptacle before maintaining.
!
Dispose of used coolant according to national, state, and local codes. Do not pour down drain.
Changing Coolant
Drain coolant by tipping unit forward. Fill with clean water and run for 10 minutes. Drain and refill.
NOTICE − If replacing hoses, use hoses compatible with ethylene glycol, such as Buna-n, Neoprene, or Hypalon. Oxy-acetylene hoses
are not compatible with any product containing ethylene glycol.
Contact Factory Authorized Service Agent to clean or change filter.
OM-254203 Page 8
Z = Change
~ = Clean
Clean coolant strainer. Severe condi-
nl Labels
Δ = Repair
~ Blow out heat exchanger fins.
nCheck coolant level. Top off with
distilled or deionized water if necessary.
Change
Coolant (If
Using Water)
ZReplace coolant.
!
Disconnect power
before maintaining.
l = Replace
Ref. coolmaint_2016-08