Miller Coolmate 3.5 CE Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller Coolmate 3.5 CE. Miller Coolmate 3.5 CE 20 stron.
Drukuj stronę
5-3. GMAW Connections
2
!
Do not move or operate unit where
it could tip.
To prevent overheating, make sure cooling
unit is positioned so airflow is not restricted.
NOTICE − If welding power source has a
water valve, do not connect hoses to water
valve. Connect hoses as shown.
1
Coolant Out Hose
2
Coolant In Hose
OM-231313 Page 10
.
A complete Parts List is available at www.MillerWelds.com
4
3
1
Fittings have 5/8-18 left-hand threads.
Connect hoses with proper fittings as
shown.
3
Coolant Tank Cap
4
115 Volt AC Grounded Receptacle
An individual branch circuit capable of car-
rying 15 amperes and protected by fuses
or circuit breakers is recommended. Rec-
Tools Needed:
5/8 in.
Ref. 804845-C
ommended fuse or circuit breaker size is
15 amperes.
Operation:
Fill tank with proper coolant. Use table in
Section 4-3 to select proper coolant. Main-
tain coolant level at approximately 1 in (25
mm) below top of filler neck. Connect
hoses as shown. Unit turns on when
plugged in.