Miller CP-252TS Instrukcja obsługi - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller CP-252TS. Miller CP-252TS 32 stron.
Drukuj stronę2-6.
Typical MIG Process Connections Using A Constant Speed Wire Feeder
Constant
Speed
Wire Feeder
Gun
Workpiece
Work Clamp
2-7.
Typical MIG Process Connections Using A Voltage-Sensing Wire Feeder
Gun
Workpiece
Work Clamp
Voltage
Sensing Clamp
OM-259 Page 12
14-Pin Interconnecting Cord
Regulator/
Flowmeter
Shielding Gas
(When Required)
Gas
Electrode Lead
Work Lead
Voltage
Sensing Wire
Feeder
Electrode Lead
Work Lead
Y Weld current can damage
electronic parts in vehicles.
Disconnect
cables before welding on a
vehicle. Place work clamp as
close to the weld as possible.
Constant
Constant speed wire feeders are
Voltage
used with constant voltage (CV)
(CV)
power sources having a 14-pin re-
Welding
ceptacle.
Power
.
For
flux
Source
(FCAW), contact welding wire
manufacture for polarity rec-
ommendations.
Y Weld current can damage
electronic parts in vehicles.
Disconnect
cables before welding on a
vehicle. Place work clamp as
Constant
close to the weld as possible.
Current (CC)
Voltage sensing wire feeders are
Or Constant
used with constant current (CC) or
Voltage (CV)
constant voltage
Power Source
sources (14 pin receptacle not re-
quired).
If using a CC welding power source
without a weld output contactor, use
optional secondary contactor.
For GMAW, use optional gas valve.
both
battery
cored
welding
mig 9/99 / Ref. ST-800 357-A
both
battery
(CV)
power
802 488