aquanta AQ-CA-E300-1 Instrukcja instalacji - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Kontroler aquanta AQ-CA-E300-1. aquanta AQ-CA-E300-1 12 stron. Smart water heater controller
Drukuj stronę
LED and Audible Indications
LED Color
Green
Red
Aqua, Blue, Purple
LED Blinking
Beeping
Aquanta Override and (Wifi) Reset
You can force Aquanta to activate your hot water heater permanently by
pressing and holding the Mode button on the right side of the Aquanta
unit for 10 seconds, then release the button and cycle the water heater
circuit breaker OFF and back ON. This also allows it to reset Wifi Access
Point credentials.
Indication
Normal operation with AC power applied to the hot water
cylinder.
Aquanta is preventing the water heater from heating which means
you have to put Aquanta in Away Mode, or you have to set a
Schedule.
Aquanta Intelligent Mode Operation
Wireless connection to the server is not available.
Leak Sensor has detected a water leak. Check you water heater
to determine the source of the leak. To stop the beeping, unplug
the Leak Sensor from Aquanta, remove the sensor from the water
and dry it with a soft cloth. Allow at least 24 hours for the Leak
Sensor to thoroughly dry before plugging it back into Aquanta.
11