Miller XMS 425 MPa CE Instrukcja obsługi - Strona 23
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller XMS 425 MPa CE. Miller XMS 425 MPa CE 40 stron.
Drukuj stronę
4-9. Wire Feeder Connections
3
2
4
5
6
7
8
4-10. 6-Pin Receptacle Information
*The remaining sockets are not used.
1
4
5
6
REMOTE 6−PIN
23 VAC
(FEEDER
POWER)
CAN BUS
SIGNALS
(FEEDER
COMMUNI-
CATIONS)
956172246_10-A
1
Gas Cylinder (See Section 4-6)
2
Gas Fitting (See Section 4-6)
3
Wire Feeder
.
Welding power source can only
be used with XMS 425 wire feed-
er.
4
6-Pin Cord (See Section 4-10)
Provides 23 VAC to power wire feed-
er and CAN bus signal communica-
tion to feeder.
5
Cable, Positive
Connect to weld output terminal for
MIG welding located on the rear pan-
el of the welding power source.
6
Water In/Out Connections
Connect to water in/out quick con-
nectors located on the rear panel of
the cooler.
7
Welding Power Source
8
Cooler
Socket*
Socket Information
A
23 VAC
B
23 VAC com
D
CH-L
E
CH-H
F
CH-GND
Tools Needed:
17 mm
956172246_9-A
OM-274462 Page 17