Miller XMS 425 MPa CE Instrukcja obsługi - Strona 33

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller XMS 425 MPa CE. Miller XMS 425 MPa CE 40 stron.

Drukuj stronę
Miller XMS 425 MPa CE Instrukcja obsługi

6-3. Troubleshooting

Trouble
No weld output; unit completely inop-
erative.
No weld output; meter display On.
Erratic or improper weld output.
No 115 volts AC output at duplex re-
ceptacle or Remote 14 receptacle.
No 24 volts AC output at Remote 14
receptacle.
Notes
Place line disconnect switch in On position (see Section 4-15).
Check and replace line fuse(s), if necessary, or reset circuit breaker (see Section 4-15).
Check for proper input power connections (see Section 4-15).
Input voltage outside acceptable range of variation (see Sections 4-15, 4-14).
Check, repair, or replace remote control.
Unit overheated. Allow unit to cool with fan On (see Section 3-5).
Use proper size and type of weld cable (see Section 4-2).
Clean and tighten all weld connections.
Check for correct polarity.
Reset supplementary protector CB1 (see Section 4-5).
Reset supplementary protector CB2 (see Section 4-5).
Remedy
OM-274462 Page 27