Miller XT30 Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller XT30. Miller XT30 44 stron. Air plasma cutting and gouging
Również dla Miller XT30: Instrukcja obsługi (40 strony)
Drukuj stronę
3-1.
Additional Safety Symbols And Definitions
�
Some symbols are found only on CE products.
3-2.
Miscellaneous Symbols And Definitions
Amperage
Voltage
Protective Earch
(Ground) GND/PE
Rated No-Load Volt-
age (OCV)
Rated Supply
Voltage
Primary Voltage
Conventional Load
Voltage
Rated Maximum
Supply Current
Rated Current
Maximum Effective
Supply Current
Internal Protection
Rating
OM-253555 Page 10
Do not fuel a hot engine.
�
Complete Parts List is available at www.MillerWelds.com
SECTION 3 – DEFINITIONS
Use lift eye to lift unit and properly installed accessories only, not gas cylinders. Do not exceed maximum lift eye
rating (see Specifications).
When power is applied failed parts can explode or cause other parts to explode.
Flying pieces of parts can cause injury. Always wear a face shield when servicing unit.
Always wear long sleeves and button your collar when servicing unit.
After taking proper precautions as shown, connect power to unit.
On
Off
Disconnect input plug or power before working on machine.
Warning! Watch Out! There are possible hazards as shown by the
symbols.
When power is applied failed parts can explode or cause other parts
to explode.
Plasma Arc Cutting
(PAC)
Increase/Decrease
Of Quantity
Single Phase
Loose Torch Shield
Cup
Adjust Air/Gas
Pressure
Prohibited
Drooping Character-
istic (Constant
Current)
Percent
Duty Cycle
Input
Suitable For Cutting
In An Environment
With Increased Risk
Of Electric Shock
Low Air Pressure
Light
Temperature
Indication
Input Power Or In-
put Voltage
Direct Current (DC)
Line Connection
Single-Phase Static
Frequency Convert-
er-Transformer-
Rectifier
Hertz
Power Rating: Prod-
uct Of Voltage And
Current (kVA)
Look Under Unit For
Label
Power
Safe24 20
Safe25 20
Safe26 201
Safe27 201
Safe28 201
Safe29 201
Safe30 20