Miller XT30i Instrukcja obsługi - Strona 20
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System spawania Miller XT30i. Miller XT30i 44 stron.
Drukuj stronę
5-1. Serial Number And Rating Label Location
The serial number and rating information for this product is located on the back. Use rating label to determine input power requirements and/or rated
output. For future reference, write serial number in space provided on back cover of this manual.
5-2. Selecting A Location
Movement
Location And Airflow
460 mm
(18 in.)
OM-256 118 Page 16
.
A complete Parts List is available at www.MillerWelds.com
SECTION 5 − INSTALLATION
!
Do not move or operate unit
where it could tip.
1
3
460 mm
(18 in.)
1
Lifting Handle
Use handle to lift and move unit.
2
Line Disconnect Device
Locate unit near correct input
power supply.
!
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
Ref. 244 405-A