Miller ArcStation Instrukcja obsługi - Strona 18
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria spawalnicze Miller ArcStation. Miller ArcStation 44 stron.
Również dla Miller ArcStation: Instrukcja obsługi (20 strony)
Drukuj stronę
C. Front/Rear Rails
1
1
Bottom View
D. End Subframes
Tools Needed:
hex bit 3/16 in.
CC or AA
and WW
3/16 in. thick top uses CC and WW
3/8 in. thick top uses AA and WW
OM-244 997 Page 14
2
1
1
1
1
Bottom View
2
3/16 in. thick top uses DD and WW
3/8 in. thick top uses CC and WW
1
Tapped Holes For Front/Rear
Rails
2
Front/Rear Rails
Place two front/rear rails on table
top as shown, but do not fasten rails
to top yet.
1
Tapped Holes For End
Subframes
1
2
End Subframes
Place end subframes on table top
as shown. Fasten one subframe at
a time to ease installation. Table top
hardware will be used at this point.
3/16 in. Thick Top
1
Use four bolts DD and four washers
WW. Install bolts into table top
ends.
Use four bolts CC and four washers
WW. Install bolts into slotted holes
for the end subframes and rails.
3/8 in. Thick Top
Use four bolts CC and four washers
WW. Install bolts into table top
ends.
Use four bolts AA and four washers
WW. Install bolts into slotted holes
for the end subframes and rails.
Tighten all bolts at this point.
DD or CC
and WW