Miller Infinity Series Instrukcja obsługi - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria spawalnicze Miller Infinity Series. Miller Infinity Series 32 stron. Auto-darkening helmets
Również dla Miller Infinity Series: Instrukcja obsługi (32 strony)
Drukuj stronę
5-6.
Sensitivity Control
2
1 Sensitivity Adjustment Buttons
2 Mode Button
Use control to make the lens more respon-
sive to different light levels in various welding
processes. Use a Mid-Range or 30-50%
sensitivity setting for most applications.
It may be necessary to adjust helmet sensi-
tivity to accommodate different lighting condi-
tions or if lens is flashing On and Off.
The sensitivity ranges for each mode are as
follows:
Weld, Cut, X-Modes - 0–10
Grind Mode - No sensitivity adjustment
Do not weld in the Grind mode; the
lens will not darken.
Sensitivity Adjustment Procedure
�
Adjust helmet sensitivity in lighting con-
ditions helmet will be used in.
� Press Mode button to turn helmet On.
� Press Mode button to select desired
function: Weld, Cut, or X-Mode.
� Use Sensitivity Less and More buttons
to adjust sensitivity control to lowest
setting.
Stick Electrode
Short Circuiting (MIG)
Pulsed And Spray (MIG)
Gas Tungsten Arc (TIG)
Plasma Arc Cutting/Welding
(R)
MEMO(B)
Recommended Sensitivity Settings
� Face the helmet in the direction of use,
exposing it to the surrounding light
conditions.
� Press sensitivity More button until the
lens darkens, then press Less button un-
til lens clears. An alternative method is
to press and hold the Less button until
the lens clears.
Helmet is ready for use. Slight readjustment
may be necessary for certain applications or
if lens is flashing on and off.
�
Reduce Sensitivity setting if lens stays
dark longer than Delay setting.
This lens also features AutoSense™, which
allows users to push and hold only one but-
ton for the lens to adjust sensitivity to the
proper setting while in Weld mode.
� To initiate AutoSense, face helmet to-
ward workpiece and push and hold the
Less/AutoSense button until screen indi-
cates that it is adjusting.
� Lens will then set to current lighting con-
ditions and can be fine tuned for
preference.
Mid-Range
Low/Mid-Range
Mid-Range
Mid/High-Range
Low/Mid-Range
ARC
TIME
COUNT
MEMO
1
2
1
OM-289711 Page 17