Miller RFCS-6M Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria spawalnicze Miller RFCS-6M. Miller RFCS-6M 16 stron. Foot controls
Również dla Miller RFCS-6M: Instrukcja obsługi (12 strony), Instrukcja obsługi (16 strony)
Drukuj stronę
1-6. Adjusting Potentiometer Timing
BEFORE RE-INSTALLING BELT, TURN GEAR ALL
THE WAY TO THE STOP.
AVANT DE REPOSER LA COURROIE, FAIRE
PIVOTER L'AXE JUSQU'À LA BUTÉE.
ANTES DE VOLVER A INSTALAR LA CORREA DÉ
VUELTA AL ENGRANAJE TODO LO NECESARIO
HASTA QUE SE DETENGA.
1-7. Changing Cord Location On RFCS-5HD, RFCS−6MHD, And RFCS-14HD Models
1
2
1
2
218 006-A
NOTICE − Disconnect foot control
from welding power source/gener-
ator before adjusting potentiome-
ter.
Turn unit upside down, and remove
bottom plate.
1
Label
2
Gear
Turn gear on potentiometer shaft
counterclockwise as far as
possible.
Pull drive belt tight and mesh belt
teeth with gear teeth.
Connect free end of small spring
into end of drive belt.
Reinstall bottom plate
NOTICE − Disconnect foot control
from welding power source/gener-
ator before adjusting potentiome-
ter.
1
Bottom Plate
Turn unit upside down, and remove
bottom plate.
Remove screw that holds cord in its
factory installed location.
2
Cord Slots
Position cord in desired slot.
Slide strain relief down cord and
into slot to protect cord. Secure
cord with screw in the same man-
ner in which it came from the
factory.
Reinstall bottom plate
OM-844 Page 5