Miller RPC-IP Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria spawalnicze Miller RPC-IP. Miller RPC-IP 13 stron. Remote pendant control

Drukuj stronę

Figure 1-1. Dimensions

1-1. GENERAL INFORMATION AND SAFETY

A. General

Information presented in this manual and on various la-

bels, tags, and plates provided on this unit pertains to

equipment design, installation, operation, maintenance,

and troubleshooting which should be read, understood,

SECTION 1 – INTRODUCTION

5-3/4 in.

(141 mm)

9-3/8 in.

(238 mm)

5 in.

(123 mm)

ST-109 521-A

and followed for the safe and effective use of this equip-

ment.

B. Safety

The installation, operation, maintenance, and trouble-

shooting of arc welding equipment requires practices

and procedures which ensure personal safety and the

safety of others. Therefore, this equipment is to be

installed, operated, and maintained only by qualified

persons in accordance with this manual and all applica-

ble codes such as, but not limited to, those listed in Arc

Welding Safety Precautions Section in the welding pow-

er source Owner's Manual.

Safety instructions specifically pertaining to this unit ap-

pear throughout this manual highlighted by the signal

words WARNING and CAUTION which identify different

levels of hazard.

WARNING statements include installation, operation,

and maintenance procedures or practices which if not

carefully followed could result in serious personal injury

or loss of life.

CAUTION statements include installation, operation,

and maintenance procedures or practices which if not

carefully followed could result in minor personal injury or

damage to this equipment.

A third signal word, IMPORTANT, highlights instructions

which need special emphasis to obtain the most efficient

operation of this equipment.

1-2. RECEIVING-HANDLING

Before unpacking equipment, check carton for any dam-

age that may have occurred during shipment. File any

claims for loss or damage with the delivering carrier.

Assistance for filing or settling claims may be obtained

from the distributor and/or the equipment manufactur-

er's Transportation Department.

When requesting information about this equipment, al-

ways provide the Model Description and Serial Number.

1-3. DESCRIPTION

This unit is a Remote Pendant Control for the Intellipulse

welding power source. When properly connected to the

welding power source this unit provides arc control, con-

tactor control, voltage/amperage control, CV/CC selec-

tion, and pulse frequency selection.

OM-533 Page 1