Miller S-74 Boom w/Drive Instrukcja obsługi - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria spawalnicze Miller S-74 Boom w/Drive. Miller S-74 Boom w/Drive 32 stron. Boom w/drive
Również dla Miller S-74 Boom w/Drive: Instrukcja obsługi (32 strony)
Drukuj stronę
4-3. Adjusting Control Tilt Bracket
4-4. Installing Boom And Reel Support
4
5
6
1
Tools Needed:
3/8, 3/4 in.
OM-252 045 Page 12
1
2
3
3
7
2
1
Tilt Bracket
2
Rear Pivot Screw
3
Front Screw
Loosen rear pivot screw. Remove
front screw. Pivot control down-
ward to desired viewing angle. Re-
place and tighten front screw. Tight-
en pivot screw.
805 413-A
1
Swivel Plates
2
Yoke
Remove hardware from swivel
plates and yoke.
3
Boom
Set boom into swivel as shown.
4
Yoke Pin
Install pin through yoke. Install cot-
ter pin and spread ends.
5
Bolt
Install bolt, tighten hardware, and
back bolt off one half turn.
6
Locking Knob
Install locking knob but do not
tighten.
7
Reel Support
Install reel support.
142 596-D