Miller Soft Start 2F Instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria spawalnicze Miller Soft Start 2F. Miller Soft Start 2F 24 stron. Om-189 112

B. Power Connections to a Maxstar 91 or 152 Welding Power Source

NOTE

Parts needed for this procedure are

supplied with the high-frequency unit.

Tools Needed:

OM-189 112 Page 12

Be sure that the Soft Start is a 230 VAC model.

Internal connections cannot be made to a

Maxstar 175 for input power.

Welding Power Source

Remove wrapper.

Snap-In Blank

Remove blank and install supplied

bushing into hole.

Control Relay CR1

Plug PLG11

PLG11 is secured in a lead bundle

near control relay CR1. It may be

necessary to remove cable tie to

access PLG11.

Protective Blank

Remove blank from PLG11.

Position welding power source

above high-frequency unit, and

route RC11 through bushing in

welding power source case bottom.

Connect plug PLG11 to receptacle

RC11. Use cable ties to secure

leads to lead bundle in welding

power source so leads are away

from fan blade.

Reinstall welding power source

wrapper.

Install mounting brackets accord-

ing to Section 3-4.