Miller SUITCASE 12RC Instrukcja obsługi - Strona 18
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria spawalnicze Miller SUITCASE 12RC. Miller SUITCASE 12RC 40 stron. Wire feeder with gun and meters
Również dla Miller SUITCASE 12RC: Specyfikacje (2 strony), Instrukcja obsługi (36 strony), Instrukcja obsługi (40 strony)
Drukuj stronę
5-3. Connecting Welding Gun
1
Gun Locking Tab In Place
Internal Side View
OM-263984 Page 14
5
2
Gun Locking Tab Out Of Place
3
4
6
!
Turn Off wire feeder and
welding power source.
Stop engine on welding
generator.
1
Gun Securing Knob
2
Gun Block
3
Gun Power Pin
4
Power Pin Groove
5
Gun Locking Tab
5
Loosen gun securing knob, insert
gun power pin into gun block. Po-
sition power pin as close as pos-
sible to drive rolls without touch-
ing. Align the gun power pin
groove with the gun locking tab.
Tighten gun securing knob.
If the gun power pin does not
have a groove, loosen knob to ro-
tate the gun locking tab 180 de-
grees. This prevents the gun
locking tab from interfering with
the gun power pin when inserted
into the gun block. Insert the gun
power pin into the gun block. Pos-
ition power pin as close as pos-
sible to drive rolls without touch-
ing them. Tighten gun securing
knob.
6
Gun Trigger Plug
7
Gun Trigger Receptacle
Connect gun trigger plug to gun
trigger receptacle.
7
256 617-A / 263 839-A