Miller 1036 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Miller 1036. Miller 1036 13 stron. Fluid head

Drukuj stronę

Introduction

Thank you for purchasing the Compass 20 Fluid Head. The

Compass 20 Fluid Head has been designed to suit payload

capacities from HDV to standard configuration XDCAM and P2HD

cameras.

The robust design and construction of the Compass 20 Fluid Head

offers maximum stability, accuracy and durability and includes

precision ball bearing mounted Fluid Drag Plate system in the Pan

and Tilt assembly to deliver true fluid drag performance over the

entire temperature and payload range.

The Fluid Drag and the Counterbalance system were designed to

provide excellent control and repeatability and offer progressive

equal increments of drag and torque.

The Compass 20 Fluid Head also offers Illuminated Bubble level.

The Compass 20 Fluid Head will give best performance when

used on a wide range of Miller tripods, including SOLO DV

(#1501 & 1630) and Lightweight (#440 & 420) tripod. This will

ensure maximum system stability to suit any professional set-

up. The Compass 20 Fluid Head will suit most industry standard

75 mm tripods as well, please refer to manufactures' manual for

mounting details.

Safety Instructions

Attaching/removing the camera.

Please use this manual to familiarise yourself with the operation

of the Compass 20 Fluid Head and observe these instructions

to prevent any damage to your equipment. Ensure that all

equipment is operating correctly and free from defects and

damage, also please ensure that the tripod is steady, secure and

that the bowl is approximately horizontal when attaching the

camera. The operator is responsible for the safe operation of this

piece of equipment.

•

Do not exceed the maximum payload capacity of the

Fluid Head.

•

Do not leave the camera unattended on the Fluid Head.

•

Do not release the SLIDING PLATFORM LOCK whilst the

camera is at an angle.

•

Do not adjust the tripod whilst the camera is attached

to the Fluid Head.

•

Ensure PAN HANDLE CLAMP and CLAMP NUT is

securely tightened.

•

Apply TILT LOCK when adding/removing equipment from the

camera or when attaching/removing the camera from the

Fluid Head.

•

Hold camera securely whilst changing Counterbalance, Pan

Drag or Tilt Drag settings.

•

Hold the camera securely whilst releasing the

RELEASE KNOB.

•

Hold camera securely whilst adjusting the CLAMP NUT to

level the Fluid Head.