Miller arrow 25 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Miller arrow 25. Miller arrow 25 13 stron. Fluid head
Drukuj stronę
Operating Instructions
3. Counterbalance Control
The counterbalance system was designed to neutralise the
effect of the camera weight when it is tilted. The Arrow 25
Fluid Head offers a 4 position counterbalance system which
can be operated via the COUNTERBALANCE SELECTOR (fig.
1). The COUNTERBALANCE SELECTOR must be operated
when the SLIDING PLATFORM is in a horizontal position. After
changing the Counterbalance setting it may be necessary to
tilt the camera back and forth to ensure that the CB spring has
engaged. The camera must be held securely while changing
the Counterbalance setting.
3.1 For safety ensure that Counterbalance position 4 is
selected.
3.2 Hold the camera and release the TILT LOCK, then gently
tilt the camera from a horizontal position forward then
backward and observe its response. If the Camera
'Springs Back' to the horizontal position then a lower
Counterbalance setting is required, select Counterbalance
position 3 and recheck, select lower setting again if
necessary. Correct counterbalance setting has been
acheived when minimum effort is required to move the
camera over the entire tilt range.
TIP Fine tuning can be achieved by adjusting the SLIDING
PLATFORM – see step 2.6.
Counterbalance Performance
300
250
200
150
100
50
0
2
4
Fig. 6
7
6
8
10
12
14
16
Camera Payload (kg)
18
20