Miller compass 20 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Miller compass 20. Miller compass 20 13 stron. Fluid head

Operating Instructions

The operating instructions are described in six steps. Please read

and understand these instructions before using this equipment.

Do not omit any steps.

1 Fluid Head Set-up

1.1 Loosen the PAN HANDLE CLAMP fully then rotate the

PAN HANDLE until it is approximately perpendicular to the

THREADED STUD (fig. 4) and tighten the PAN HANDLE

CLAMP - avoid contact wear between the serrations on

the Fluid Head and the PAN HANDLE CLAMP , if this occurs

then unwind the PAN HANDLE CLAMP further.

1.2 Ensure that the TRIPOD BOWL is approximately horizontal.

Place the Fluid Head into the TRIPOD BOWL, adjust the

BUBBLE LEVEL (fig. 4) such that the bubble is inside the

black circle and tighten the CLAMP NUT.

1.3 Set the initial control settings as follows – see Figure 1 & 2:

• Select Counterbalance to position 4 (top setting).

• Select Pan & Tilt Drag to position 0.

• Tighten the PAN LOCK, TILT LOCK and the SLIDING

PLATFORM LOCK.

Pan Handle Clamp

Pan Handle

Illumination Button

Bubble Level

Threaded Stud

Clamp Nut

Fig. 4