AquaOne CTP-14000 Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pompa wodna AquaOne CTP-14000. AquaOne CTP-14000 15 stron. Eco pump

Drukuj stronę
Trouble Shooting
Malfunction
Pump does not turn on
Noise
Insufficient water
displacement
Regulations for waste disposal
The Waste Electrical and Electronic Equipment Directive (WEEE Directive,
2012/19/EU) of the EU was implemented in the German law related to
electrical and electronic equipment and appliances.
All AquaOne electric devices that fall under the WEEE directive
are labelled with the symbol of a crossed- out wheeled rubbish
bin. This symbol indicates that this electric device must not be
disposed of with the domestic waste.
Disposal of used electrical and electronic devices (in- tended for use in the
countries of the European Union and other European countries with a
separate waste collection system for these devices).
The symbol on the packaging or the product itself indi- cates that this
product must not be treated as normal domestic waste but must be
disposed of at a recycling collection station for electrical and electronic
waste.
By disposing of this product correctly, you contribute to the protection of the
environment and the health of your fellow people. Inappropriate disposal
threatens the en- vironment and health.
Material recycling helps to reduce the consumption of raw materials.
Additional information about the recycling of this product can be provided by
your local commune, the municipal waste disposal facilities, or the store
where you purchased the product.
By Aquaristikwelt24
Cause
 No power
 Burned
 Rotor is blocked
 Running without water
 Filter basket is blocked
or shaft broken
 Ceramic shaft or bearing
occur wearing
 Rotor subassembly
broken
 Flow rate valve is closed
 lnput&output orfilter
basket is blocked
 Low voltage
www.aquaristikwelt24.de
Remedy
 Plug in
 Change pump
 Clear blockages
 Add water and then plug
in again
 Clean blockages after
opening
 Change the shaft
orbearing
 Change rotor
subassembly
 Open the flow rate valve
 Clean blockages then
plug in
 Change to right voltage
15 |
e
S e i t