Aquaox RE Series Instrukcja obsługi i konserwacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Systemy filtracji wody Aquaox RE Series. Aquaox RE Series 4 stron.
Drukuj stronęThe FE & RE Edition, when properly applied, is an efficient and cost effective system
for the removal of iron and sulfur. The FE & RE Edition maintains a compressed "air
pocket" in the top of the tank while the system is in service. As the water passes thru
the air pocket, iron and sulfur are oxidized. Additionally, dissolved oxygen is added to
the water. The media bed then removes the iron and sulfur from the water.
A daily backwash will remove accumulated iron and replenish the filter media bed.
The regeneration process also adds a fresh air pocket to the system.
Application Parameters
pH (Minimum)
Iron (Maximum)
Sulphur (Maximum)
Installation
•
Install the FE & RE Edition after the supply lines to outside faucets (unless outside
faucets need to be free of iron). Also, install the AquaOx after any sediment filters
or neutralizing filters (ie, calcite, corosex), if applicable.
•
The FE & RE Edition should be installed before a water softener or any taste/odor
filters (if applicable).
•
Insure the inlet check valve is connected as shown to the inlet side of the control
valve. The drain line should be installed in accordance with local plumbing codes.
Due to the release of the air during regeneration, the drain line must be securely
fastened at the end, and anchored throughout the run.
•
Insure the brine line check valve with screen is installed on the brine valve. This is
the AIR DRAW point of entry.
AquaOx FE & RE Edition
General Information Specification Sheet
https://www.aquaox lters.com/re-edition
FE Filter Media
6.8
7 ppm
4 ppm
RE-Sulphur Media
6.8
2 ppm
8 ppm