Diamond 916317 Podręcznik - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik dla Komercyjny sprzęt spożywczy Diamond 916317. Diamond 916317 13 stron.
Drukuj stronę
UK
Proceed as follows (Fig. 11):
•
Switch the dishwasher off
•
Empty and clean it.
•
Remove the integral filter and open the salt container in the tub.
•
Pour in 250-300g of regeneration salt (1 or 2mm grain size kitchen salt with no additives).
•
Close the container firmly.
•
Make sure the overflow has been removed.
•
To start the cycle, with the machine off press START (3) for a few seconds.
•
The cycle is shown by the POWER (5) led coming on and the CYCLE UNDERWAY (5)led flashing.
•
The regeneration cycle lasts around 20 minutes.
•
The dishwasher will switch off when the cycle has completed.
N.B. Do not switch the machine off during the regeneration cycle
•
At the end of the day always drain the machine as described in the section Machine draining.
•
Disconnect the power supply by means of the main switch and close the external water cock.
•
Perform routine maintenance and clean the machine as described in the section Maintenance.
•
If possible, leave the door ajar to prevent bad odours building up inside the machine.
Before doing any maintenance, completely drain out all water, shut off the power
supply and close the water supply cock.
Do not use water under pressure - it can damage the electrical equipment.
Only wash the body panelling when it is cold, using only product specifically designed for steel.
If there is a risk of ice forming, drain the water from the boiler and wash pump.
To keep the machine in good working order, it must be maintained regularly as explained below. We
recommend periodically running a sanitising treatment with suitable non-corrosive commercial
products.
Run this procedure at the end of the day or when you see the filters are dirty:
1. Remove and clean the baskets.
2. Empty out the tub as explained in "Machine draining".
3. Remove and carefully clean all the filters.
4. Do not use abrasive products to clean the tub.
5. Restore all removed parts when finished.
Page 8 of 10
INSTRUCTION MANUAL FOR DISHWASHERS
4.8