Aquaport AQP-WCS Instrukcja instalacji i obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Dozownik wody Aquaport AQP-WCS. Aquaport AQP-WCS 12 stron. Executive water cooler cold and room
Drukuj stronęA. EXECUTIVE WATER COOLER INSTALLATION
FOR SPRING WATER BOTTLES.
Please follow the instructions below if you are using a spring water
bottle.
Do not turn on the water cooler until the following instruction have
been followed.
1. Vertically insert a spring water bottle into the bottle supporter on
top of the water cooler, the spike will pierce the bottle cap. You
will see bubbles appear inside the bottle, wait until the bubbling
has stopped before dispensing water form both taps
Note:
If you are applying a spring water bottle to the water cooler for
the first time and you do not see any bubbles appear inside the bottle,
open both taps until the bubbling starts and water flows from both
taps. Refer to the trouble shooting guide for more information.
2. Once the bubbling has stopped, drain 1-2lts of water from both
taps.
Note:
The water cooler has been flushed before it left the factory
however we strongly recommend 2-3lts of water is flushed through
the unit before using.
3. Insert the power plug into the wall socket, and turn the green
power switch ON. The power switch is situated at the rear of the
unit.
4 INSTALLATION AND OPERATING INSTRUCTIONS
4. At the front of the unit there are 3 indicator lights, the red LED
on the right is the power light and will continually illuminate while
the unit is turned on. The Green LED cooling light on the left will
illuminate when the compressor is running and cooling the water.
When cooling is finished the Green cooling LED light will turn
off and the middle Yellow Auxiliary LED light will illuminate until
cooling is required again.
5. When the unit is turned on for the first time, allow the unit to cool
the water for 1-2 hours before dispensing cold water.
B. EXECUTIVE WATER COOLER INSTALLATION FOR FILTER BOTTLE.
Please follow the instructions below if you are using a filter bottle.
Do not turn on the water cooler until the following instruction have
been followed.
1. Remove the bottle support and spike from the water cooler. See
figure 1 on page 5.
2. To remove the bottle supporter there is an arrow and the word
"OPEN" embossed into the bottle support. Line this up with the
small sticker found on the top panel of the water cooler that also
has an arrow the word "OPEN". Then grab the bottle supporter by
placing your fingers under the rim and vertically pull off.
3. When the bottle support is removed you should be able to see
inside the stainless steel cooling tank.