Aquaport AQP-FKW Podręcznik - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik dla Systemy filtracji wody Aquaport AQP-FKW. Aquaport AQP-FKW 16 stron. Full flow water filtration system
Drukuj stronę
INSTALLATION GUIDE
Preferred installation utilising existing water supply and flexible
cold water hose is shown on Page 3.
Note: Plumbing connections may vary, please consult a qualified
plumber for correct installation method for your home.
1. Water Supply Installation
a) Locate cold tap water pipe and turn water supply off
at the isolation tap. If no isolation tap is available, turn
water off at the meter. Turn on tap at sink to ensure
water is turned off and to drain the pipe.
b) Remove the flexible cold water hose that connects the
cold water faucet to the cold mains connection. Some
water may spill out.
c) Wrap plumbing tape around cold water stud in a
clockwise direction.
Note: Do not apply plumbing tape in a counter clockwise
direction, it releases the plumbing tape and leaks may occur.
d) Hand tighten the brass dual check valve (4) to the
mains cold water stud (please see Fig 1). Water flow
should be in the direction of the arrow on dual check
valve. Finish tightening with an adjustable wrench.
Be careful not to over tighten, as cross threading and
leaking can occur.
4 INSTALLATION AND OPERATING INSTRUCTIONS
IMPORTANT: It is a legal requirement under Australian Plumbing
Standards that the Dual Check Valve be installed. If this part is
not installed all warranties are null and void.
e) Wrap plumbing tape around male thread of brass dual
check valve (4) in a clockwise direction.
f) Hand tighten the Female 1/2" thread to 3/8" push in
fitting (5) to the male thread of brass dual check valve
(4).
g) Wrap plumbing tape around the male thread of the
3/8" push in fitting to male 1/2" thread fitting (6) in a
clockwise direction.
h) Hand tighten the 3/8" push in fitting to male 1/2"
thread fitting (6) onto the female thread of the existing
cold water flexible hose connected to the tap.
Fig 1
Cold
water line