AquaPRO 03AP548 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody AquaPRO 03AP548. AquaPRO 03AP548 16 stron. Pressure filter/uv clarifier
Drukuj stronę
IMPORTANT SAFEGUARDS
Please read the operating instructions and familiarise yourself with the equipment before placing it
in service. Correct and safe use of the system requires strict compliance with the safety instructions.
For safety reasons, persons less than 16 years of age or infirm persons that are not familiar with these
instructions should not use this equipment.
• For your own safety, disconnect from the power supply
before any maintenance of any equipment is attempted
on the tank or water body.
• Do not operate the filter if any components of the
system, such as the power cable, have been damaged.
• If required, hove a qualified electrician install a weather
proof power point near to the pond or water feature
(within the coble length of the filter).
• Always use a properly grounded power supply that is
connected to an RCD with a rated residual operating
current not exceeding 30mA. As per AS/NZS
3350.2.41:1997
• The drip loop method should be used to prevent water
from traveling down the cable and onto the plug or
power supply. If the plug does get wet, do not unplug
the cable. Disconnect the circuit breaker that supplies
power to the power supply point. Then unplug and
examine the plug and power supply point for presence
of water. If the power point has become wet, you should
consult an electrician before using the power point
again.
PRODUCT SPECIFIC SAFEGUARDS
• Do not submerge this filter in water!
• Do not operate the filter without water at any time,
permanent damage may occur.
• Do not look at an unshielded UV-C globe. Ultra Violet
light is harmful to your eyes and may cause blindness.
• Do not over pressurise. Max head pressure is 3m.
• The filter is designed to be used in pond environment.
It is not to be used in any other manner or purpose.
The filter should only be used with water. Do not use
the filter with any harsh chemicals such as a solvent or
petrol.
• All pumps and filters are water cooled. If the flow
becomes restricted it could cause permanent damage.
The filter needs to be cleaned regularly to prevent the
filter becoming blocked, thus causing damage. This is
not a warrantable event.
AQP AP2100UV Instructions.indd 3
AP2100UV / AP5000UV / AP10000UV
PRESSURE FILTER / UV CLARIFIERS
A Q U A T E C E Q U I P M E N T . C O M
• Always unplug the pump from the power supply when
not in use or before performing any maintenance on
the pump or on the aquarium. Never pull the power
cord to disconnect the plug from the power supply.
Grasp the plug and pull to disconnect. Care should be
taken to arrange the power cable so that it cannot be
accidentally tripped over or pulled.
• Do not install or store the appliance where it will be
exposed to extreme hot or cold temperatures. Do not
use with water above 35 ° C.
• Do not cut the cable as this will result in voiding your
warranty. The power cord cannot be replaced. If the
cord is damaged, the filter must be discarded.
• Do not attempt to repair the electrical appliance
yourself. Return to an authorized service centre or place
of purchase if a fault occurs, (regular maintenance is not
considered repair and is required by user).
27/10/16 7:53 am