Burley SOLO Instrukcja obsługi i bezpieczeństwa - Strona 5

Installing the Stroller on Your Trailer

Only install the Stroller when the trailer is unoccupied. Engage the parking

brake on your trailer and detach the trailer tow bar. (See your trailer manual for

instructions for removing the tow bar.)

1. Insert the Stroller arms into the tow bar mounts on both sides of the trailer.

The Stroller wheels should be below the Stroller arms.

2. Line up the holes in the rear of the tow bar mounts with the holes in the

Stroller arms. For 2007-2009 trailers, use the hole farthest from the Stroller

wheel. For 2010 and later trailers, the Stroller arm can be inserted farther and

the second hole used.

3. Insert the retaining pins through the holes and lock into place.

4. Close the tow bar clamps (2009 and later D'Lite and Solo only).

When finished strolling, remove the Stroller from both sides of the trailer. Do not

leave the right side Stroller wheel installed while trailering.

Attaching Wrist Tether

Loop the wrist tether around the handlebar

and slide the end of the tether through the

small loop on the other end. Tighten securely

in the center of the handlebar as shown at right.

Using Your Stroller

Test your Stroller and become comfortable with it before using it with your

children. Secure your children safely as explained in your trailer manual, and

never leave them unattended in the Stroller. Engage the parking brake whenever

you take your children in and out of the trailer.

Never leave children unattended in the Stroller. Always use

your wrist tether. Failure to do so may cause you to lose control

of the Stroller, which may cause an accident and injury.

WARNING