Diamond FVS-711/TS Podręcznik - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik dla Piekarnik Diamond FVS-711/TS. Diamond FVS-711/TS 12 stron.

After you have fixed the door in its new position, the

handle will be upside down.

To put the door in the correct position, remove the

round little cap and unscrew the screw that blocks the

handle.

To complete the operation, you need to fix the magnet-

ic sensor on the side of the door handle.

After you have removed the right hand side panel, fix

the magnetic sensor inside the control panel on the

lower corner on the right hand side of the door.

Unscrew the sensor of the fixing plate and let it pass

along with the cable under the cooking chamber until it

comes out from the left hand side of the oven.

Fix the sensor on the position indicated in the figure

here above.

Pull out the handle and fix it upside down.

Screw the fixing screw again and put the little round

cap on its position.

After you have checked the correct functioning of the

magnetic sensor and mounted the side panels again,

you need to check if the door gasket is tight.

This operation must be carried out with oven in func-

tion.

Fix the door closure adjusting the fixing screws of the

hinges and the door lock.