Aquasana AQ-5300.62 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody Aquasana AQ-5300.62. Aquasana AQ-5300.62 9 stron. Under sink

Drukuj stronę

USE & CARE

Please read all precautions and instructions carefully before using.

Use and Care

• To clean your system, wipe down the

exterior with a damp cloth.

• Do not use any strong or abrasive

cleaning agent or solvent cleaner.

Tools Recommended for

Installation:

• Variable Speed Drill w/ 7/32" Bit

• Adjustable Wrench

• Philips Head Screwdriver

• Level

• Pencil

• Measuring Tape

• Bucket

• Hammer

• Safety Glasses

Important Safeguards

• Do not install this system where the

line pressure may exceed 80 psi. The

operating pressure range for this

filter is between 20-80 psi.

• Install on COLD water lines only

(40° - 90°F).

AQ-5200

Scan to view AQ-5200 product

Scan to view AQ-5300 product

and installation videos.

• Use caution when installing the

system manifold on a cabinet wall

that backs up to a dishwasher.

Screws may exceed cabinet width.

• It is recommended that your system

be installed inside and out of direct

sunlight. The system must be

protected from both direct sunlight

and freezing temperatures.

• Filter usage must comply with all

state and local laws.

• Do not operate without the

filters installed.

• The filter housing must be replaced

every five years. Failure to do so

could result in potential leaks due

to product deterioration. To order,

please call Customer Support at 866-

662-6885.

• Do not use with water that is

microbiologically unsafe or of

unknown water quality without

adequate disinfection before or after

the system.

• Systems certified for cyst reduction

may be used on disinfected waters

that may contain filterable cysts.

AQ-5300

AQ-5300+

Scan to view AQ-5300+ product

and installation videos.

This system requires an existing faucet hole at least 1/2" (13mm) in diameter

in the sink or countertop to install the supplied dedicated faucet. You may also

replace an existing kitchen sink sprayer, soap dispenser, or pre-existing hole on

the sink or countertop.

If you elect to drill a new hole for the dedicated faucet installation, we strongly

recommend consulting a professional. Please wear safety glasses when drilling.

Setup

A. Unpack and unwrap box contents.

B. Turn off the cold water supply. Turn on

the kitchen faucet to release pressure

and allow water to drain from the line.

C. Disconnect the cold water supply using

a wrench.

Attach Brass Tee and Tubing

A. Attach threaded ends of brass tee to the

cold water supply line and shut-off valve.

Tighten with wrench.

B. Attach white tubing to brass tee by sliding

the compression nut onto white tubing

with threads of the nut facing the end of

the white tube.

C. Slide plastic sleeve onto the white tube.

Place brass tee insert into the opening of

the white tube. Push the tip of the white

tubing into the opening of the brass tee.

While holding the white tube in place,

tighten the compression nut to compress

the plastic sleeve and create a seal.

INSTALLATION STEPS