Aquasana AQ-SFRO Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody Aquasana AQ-SFRO. Aquasana AQ-SFRO 13 stron. Under sink water filter smartflow reverse osmosis

Drukuj stronę

INSTALLATION STEPS

Insert Filter Cartridges

A. Insert each filter cartridge into its designated location in the system

manifold by turning to the right. Ensure filter cartridge handle is vertical

to the system manifold before inserting. The guides on each filter will

ensure proper alignment within the system manifold.

r t

I n s e

d l e

H a n

l l y

t i c a

V e r

B. Once the filter is engaged, push the filter

fully in while rotating 90 degrees to the

right. Continue this step for each filter.

· Top filter: Carbon Block

· Middle filter: SmartFlow™ Membrane

· Bottom filter: Advanced Carbon Block

L o c k

i n

H o r i z

o n t a l

l y

Pressure Test, Check for Leaks, and Flush

A. Turn off dedicated faucet.

B. Turn on COLD water supply valve.

C. Turn on kitchen faucet to release air from pipes. Once water is flowing

normally, turn off kitchen faucet.

D. Within approximately two hours, pressure will build in the system.

During this time, carefully inspect all connections and fittings for leaks.

E. After ensuring all connections and fittings are secured, turn on the

dedicated faucet and let water flush until the tank empties and the flow

from the faucet slows to almost nothing. Close the faucet, wait two more

hours for the tank to fill again, and empty the tank. Repeat this step two

more times.

NOTE: Water flow rate will be slow during initial flush. A bubbling noise can be

expected. Do not drink the flushed water.

F. Once you have emptied three tanks of water, close all faucets and refill

for regular use.

NOTE: After initial system flush, it will take 1-3 hours for the water tank to fill.

INSTALLATION STEPS