Aquasana AQ-UV-10C Instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody Aquasana AQ-UV-10C. Aquasana AQ-UV-10C 20 stron. Whole house uv filter
Również dla Aquasana AQ-UV-10C: Instrukcja obsługi i instalacji (16 strony)

Drukuj stronę

OPERATING THE CONTROLLER

Lamp Replacement

After the UV Lamp is expired, it must be replaced with a genuine Aquasana

replacement. See data plate on UV Reactor for model number.

Replace the UV Lamp by unplugging the power to the UV Controller and refer

to installation manual (or installation steps starting with step 9).

To reset the timer in the Controller, firmly hold down the button on the

Controller for 10 seconds. The Controller will read "rSt3", "rSt2", "rSt1" and

then beep. The button can now be released, the UV Lamp countdown timer

has been reset.

System Troubleshooting

Hard Alarms: The following give a constant audible alarm.

SYSTEM

DISPLAY

After any hard alarm, the home or facility should be disinfected. Follow the steps under the

"System Disinfection" section.

Boil Water Advisory

If any failure occurs on a Aquasana UV system, the water must not be used

for human consumption until the system is returned to a safe operational

mode. If the water is used for human consumption during this period,

the water must be boiled (minimum 20 minutes at a full boil) prior to

consumption.

PROBLEM

The system has detected a

problem with the UV Lamp.

Although the UV Lamp is

illuminated, due to its age

the UV output is insufficient

for proper disinfection.

WARNING

RESOLUTION

Reset UV Lamp protection

circuit by unplugging

the unit for 10 seconds.

Replace the UV Lamp

with a genuine Aquasana

replacement

part as indicated on the

data plate on the

UV Reactor.

Replace the UV Lamp

with a genuine Aquasana

replacement part as

indicated on the data

plate on the UV Reactor.