Aquasana Claryum Direct Connect Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody Aquasana Claryum Direct Connect. Aquasana Claryum Direct Connect 12 stron. Under sink water filter
Drukuj stronę
2
USE & CARE
2
Please read all precautions and instructions carefully before using.
Use and Care
• To clean your system, wipe down
the exterior with a damp cloth.
• Do not use any strong or abrasive
cleaning agent or solvent cleaner.
Important Safeguards
• Do not install this filter where the
line pressure may exceed 125 psi.
The operating pressure range for
this filter is between 10psi – 125psi.
• Install on COLD water lines only
(35° – 100°F).
• Use caution when installing the
unit on a cabinet wall that backs
up to a dishwasher. Screws could
exceed cabinet width.
• It is recommended your system be
installed inside and out of direct
sunlight. The unit must be
Tips for Quick-Connect Fittings
To Connect:
1. Measure 1/2" from the end
of the tube and mark with
a permanent marker.
2. Create a clean square edge for
each tube by cutting the end
with a utility knife.
Lock Sleeve
protected from both direct sunlight
and freezing temperatures.
• Filter usage must comply with all
state and local laws.
• Do not operate without the filters
installed.
• Do not use with water that is
microbiologically unsafe or of
unknown water quality without
adequate disinfection before or
after the system.
• Water with sediment may require
a filter change sooner than 784
gallons or 6 months.
To Disconnect:
1. Gently push the "Lock Sleeve"
down with two fingers.
2. Pull tube to remove.
Scan to view
the Claryum
®
Direct Connect
product and
installation
videos.