Diamond Antenna 150MVHS Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Antena Diamond Antenna 150MVHS. Diamond Antenna 150MVHS 2 stron. Vhf marine antenna

Drukuj stronę
VHF Marine Antenna (Simple installation/ for Handheld transceiver)
150MVHS
Operation Instructions
To use the antenna properly, read these instructions
thoroughly before using it. Keep this manual carefully at hand
for later use.
  Warning
1.Don't touch the antenna during transmission. Touching the
antenna during transmission may cause to electrify.
2.Don't install the antenna where is easily reachable by
people. It may cause to electrify.
3.Be sure to check if nuts and screws are fastened firmly from
time to time. If those are loosened, please refasten them.
4.The connector of the coaxial cable is not waterproofed.
Please keep the connector dry. If the connector gets water,
the antenna inside may be corroded or be damaged.
5.Install the antenna vertically. If the antenna is not vertical,
the performance may be decreased.
6.The 150MVHS is VHF marine antenna. Don't use the
antenna besides this purpose. It may be damaged.
・ Installation and Management
1.Install the antenna and the antenna base (not including) to
meet the below requirements.
     Install the antenna vertically and don't get water
too much.
       
          base.
2.Install the antenna base (not including) to meet the above
requirements.
3.Lead the coaxial cable into the 16mm hole of the antenna
base and fix it by the lock nut M16 and the internal tooth
lock washer M16 (including).
4.Insert the upper element into the antenna body and fix it by
2pcs set screws M4X3 with the hexagon wrench firmly.
5.Bring the coaxial cable on board a ship and connect it with
the antenna terminal of the transceiver.
break down the coaxial cable by door etc when wiring up.
Do not pull the coaxial cable from the base section strongly.
It may be disconnected or damaged.
Recommend Antenna Base
・ CRM
・ DPK-CR
・ CRB
・ CLB
Please check those details by our web-site or
catalogs.
 Miyata Building, No.15-1,1-chome Sugamo,Toshimaku Tokyo,Japan 170-0002 TEL.03-3947-1411 FAX.03-3944-2981
・ Assembly drawing
(Parts description and number)
・ Specification
Frequency
Gain
VSWR
Max. Power Rating : 50W
Length
Wight
Rated wind velocity : 40m/sec.
Connector
Type
Though the product being purchased is manufactured under
strict quality control, if damage is caused by transporting,
ask your dealer promptly.
Design and specification of these products will be changed
for future improvement without advance notice.
DIAMOND ANTENNA CORPORATION
Home Page   http://www.diamond-ant.co.jp
Upper element (M58001)
Hexagonal wrench
(M58006)
Set screw M4x3 (M58002)
Antenna body (M58003)
(including coaxial cable section)
Base section
Lock nut M16 (M58004)
Internal tooth lock washer (M58005)
Coaxial cable
SMA-P connector
: 156-157MHz (TX),
156-162.5MHz (RX)
: 2.15dBi
: Less than 1.5 (at TX frequency)
: 0.99m
: 260g (antenna only)
: SMA-P (with 3D-2V 5m)
: 1/2 wave Sleeve type