Diamond Antenna X300NA Podręcznik

Przeglądaj online lub pobierz pdf Podręcznik dla Antena Diamond Antenna X300NA. Diamond Antenna X300NA 2 stron. 2m/70cm dual band high performance gain base station antenna

Diamond Antenna X300NA Podręcznik
2m/70cm Dual Band High Performance Gain Base Station Antenna
Description
1. High performance C-Load struc-
ture.
Liner
Phase
technology permits the antenna to
achieve high performance, high
power rating low vswr, and broader
band coverage on both 2m and
70cm bands.
2. Direct element joint structure with
two interconnected FRP outer-
shells. Enables the antenna to
maintain the same strength as one
with one piece structure. The ring
gasket makes the antenna water-
proof, and therefore maintains
performance even in rainy weather.
When required, the antenna can be
easily assembled or disassembled
by adjusting the joint bracket
accordingly.
3. Professional quality maximum
wind resistance is achieved by the
rugged structure. Superior water-
proofing
eliminates
VSWR that might otherwise
happen in climatic weather. This
antenna may also be used in seaside
or contaminated air environments
as it is rust and corrosion free.
4. Both of the bands, 2m and 70cm,
can be operated simultaneously by
using optional antenna duplexer.
5. DC ground structure, which
escapes high voltage caused by
lightning, protects your radio and
equipment.
X300A/X300NA
FREQUENCY: 144-148 MHz
Shifter
GAIN:
POWER:
IMPEDANCE: 50 Ohms
VSWR:
MAX WIND
RESISTANCE: 50m/sec (112 MPH)
MAST DIAMETER
ACCEPTED:
LENGTH:
WEIGHT:
CONNECTOR: UHF Female (X300A)
WARRANTY: 1 Year against defects
unstable
DIAMOND ANTENNA Products are distributed by RF PARTS COMPANY
435 S. Pacific Street • San Marcos, CA 92078 • (760) 744-0900
www.diamondantenna.net

Specifications

435-450 MHz
6.5 dB
9.0 dB
200 Watts
less than 1.5:1
30-62mm
(1-1/5" to 2-2/5")
2.9m (114.2")
1.9 kg (3.3 lbs.)
N Female (X300NA)
in material
or workmanship.
VSWR Charts
Adjustment
All X-Series antennas are completely
adjustment free. If VSWR of an anten-
na is extraordinarily high, see if each
connecting part is well contacted. It is
most likely due to bad contact in the
coaxial cable and/or connector connec-
tion, or soldering problem. Be sure to
use 50ohm coaxial cable to feed the
antenna.
Upper Outershell
Upper Outershell
Joint Bracket
Gasket Holder
10cm
Upper Element
Element Joint Bracket
Lower Element
Lower Outershell
Joint Bracket
Lower Outershell
Radial Element
Lock Nut
Radial Element
Assembly