Aquatec HydroPro HZ2010 Skrócona instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Pompa wodna Aquatec HydroPro HZ2010. Aquatec HydroPro HZ2010 13 stron. Air pumps

Drukuj stronę

TROUBLESHOOTING

PROBLEM

PUMP NOT WORKING

PUMP WORKING

INTERMITTENTLY

PUMP WORKING WITH

MINIMAL AIR FLOW OR

MAKING LOUD NOISES

HPRO Air Pump Z2010_Z4010 Instructions.indd 10

REASON

No Power

Bad Motor

Damaged Cable

Short Circuit/Bad Connection

Defective Lamp

Air Filter Sponge Clogged

Bad Diaphragms

Air Filter Sponge Clogged

Airline Is Kinked or Clogged

V I S I T A Q U A T E C E Q U I P M E N T . C O M

SOLUTION

Check that the plug on power cable is connected

to power and confirm that power point is

working.

Replace the air pump (if applicable).

Inspect the entire length of the air pump cable

and look for cuts or damage resulting in exposed

copper wire. Replace cable or complete unit.

Inspect the entire length of the air pump cable

and look for cuts or damage resulting in exposed

copper wire. Replace cable or complete unit.

Inspect the entire length of the lighting system

cable and look for cuts or damage resulting in

exposed copper wire. Replace cable or complete

fixture where the damage is.

Inspect the lamp socket is not damaged and

make sure that the inside of fixture is free of

moisture. Replace the lamp.

Disassemble top of pump per these instructions

and check the air filter sponge for discoloration,

caused by dust or dirt. Using a household style

vacuum cleaner, suck debris out of sponge until

visibly clean. And reinstall.

Disassemble pump per these instructions and

check the diaphragms for excessive wear and

tear or possible tearing. If diaphragm is damaged,

go ahead and replace before operating the unit

again.