Panasonic aw-he40 series Skrócona instrukcja obsługi

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Aparat cyfrowy Panasonic aw-he40 series. Panasonic aw-he40 series 2 stron. Adding another camera to existing system
Również dla Panasonic aw-he40 series: Podręcznik instalacji i konfiguracji (12 strony), Skrócona instrukcja obsługi (2 strony), Podręcznik (4 strony), Skrócona instrukcja obsługi (2 strony)

Controlling AW-HE40 Camera via AW-RM50 Wireless Remote

★ To control AW-HE40 via AW-RM50, the camera needs to be selected according to the IR ID setting (*1) set for it,

using the buttons [CAM1] – [CAM4] on the remote controller.

(*1) IR ID Setting: Enables controlling up to 4 cameras via AW-RM50.

This is a setting to prevent the interference while controlling multiple cameras.

【Location of AW-HE40 IR ID Setting】

- Camera Menu: Systems ＞ Others ＞ Others2/4 ＞ IR ID ⇒ [CAM1] – [CAM4]

★ Please confirm the following point before using the wireless remote control.

- Aim the wireless remote control at a wireless remote control signal light-sensing area (front panel or side panel) on

AW-HE40, and operate it within a range of 10 meters from these areas.

【Procedures for Major Operations】

● Controlling the power of AW-HE40 assigned to IR ID [CAM1]

① Press AW-RM50 [CAM1] button. – (Fig. 1-A)

② Hold down AW-RM50 [ON/STANDBY] button (for 2 sec). – (Fig. 1-B)

● Displaying the camera menu of AW-HE40 assigned to IR ID [CAM2]

① Press AW-RM50 [CAM2] button. – (Fig. 1-A)

② Hold down AW-RM50 [MENU] button (for 2 sec). – (Fig. 1-C)

● Registering the pan-tilt position of AW-HE40 assigned to IR ID [CAM3] in the preset memory

① Press AW-RM50 [CAM3] button. – (Fig. 1-A)

② Use the pan-tilt or zoom buttons to determine the camera angle.

③ While holding down AW-RM50 [PRESET] button, press the button corresponding to the

preset memory number you want to register in. – (Fig. 1-D)

* Using AW-RM50, up to 12 positions can be registered in the preset memories.

* If an already registered number is selected again, that preset memory position is

overwritten.

* To recall a preset memory position, press the button in which the preset memory position

is registered.

* Default Setting: [CAM1]

（(Figure 1: AW-RM50）

（B）

（A）

（D）

（C）