Aquatec Equipment AQUAPRO Series Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oświetlenie zewnętrzne Aquatec Equipment AQUAPRO Series. Aquatec Equipment AQUAPRO Series 4 stron. 12 led pond/garden light

Drukuj stronę

• Insert the Bi-pin male plug on the end

of the light cable into the transformer

and tighten the locking collar firmly. The

transformer can now be turned on.

• Once in the correct position lock the

light by tighten the thumb screws,

taking care not to over tighten.

MAINTENANCE

There is minimal maintenance required

on the AQUAPRO LED pond lights. The

light should be inspected on a regular

basis to ensure the light or cable is not

damaged in any way. Clean the lens on the

light regularly for maximum efficiency.

1 Locking Ring

2 Colour Lens Set

3 Clear Lens

12 LED POND/GARDEN LIGHT

4 Lens Seal

7 Garden Spike

5 Light Body

8 AC Adaptor

6 Weighted Base

9 Thumb Screws

IMPORTANT SAFEGUARDS

To guard against injury, basic safety precautions

should be observed including but not limited to

the following;

• The light should only be used in clean water.

Do not use the light in any solvent or flammable

liquids. Do not use in chlorinated or salt water.

• Do not operate the light if the light or any of

the components of the light such as the power

cable or AC Adaptor have been damaged.

• If the 240V plug supplying the AC Adaptor

gets wet, do not unplug the cord. Disconnect

the circuit breaker that supplies power to the

power outlet. Then unplug and examine the

plug and power outlet for presence of water. If

the power outlet has become wet, you should

consult an electrician before using the again.

• Always use a properly grounded power supply

that is connected to an RCD with a rated

residual operating current not exceeding 30mA

as per AS/NZS 3350.2.41:1997 .

INSTRUCTION MANUAL

Parts View