HP 316095-B21 - StorageWorks Edge Switch 2/24 Uwaga dotycząca wydania - Strona 22

Przeglądaj online lub pobierz pdf Uwaga dotycząca wydania dla Przełącznik HP 316095-B21 - StorageWorks Edge Switch 2/24. HP 316095-B21 - StorageWorks Edge Switch 2/24 22 stron. Edge switch release notes
Również dla HP 316095-B21 - StorageWorks Edge Switch 2/24: Aktualizacja instrukcji (9 strony), Podręcznik (41 strony), Podręcznik (40 strony), Uwaga dotycząca wydania (32 strony), Uwaga dotycząca wydania (27 strony), Podręcznik (26 strony), Uwaga dotycząca wydania (27 strony), Uwaga dotycząca wydania (25 strony), Instrukcja instalacji (24 strony), Uwaga dotycząca wydania (23 strony), Uwaga dotycząca wydania (23 strony), Uwaga dotycząca wydania (23 strony), Uwaga dotycząca wydania (19 strony), Uwaga dotycząca wydania (19 strony), Uwaga dotycząca wydania (18 strony), Instrukcja obsługi (17 strony), Uwaga dotycząca wydania (17 strony), Instrukcje aktualizacji (16 strony), Instrukcja obsługi (16 strony), Instrukcja instalacji (16 strony), Uwaga dotycząca wydania (16 strony), Uwaga dotycząca wydania (17 strony), Uwaga dotycząca wydania (17 strony), Uwaga dotycząca wydania (11 strony)

Known Issues

Possible Switch Reset After Power Failure or Power Off Sequence

In extremely rare instances, after a power failure or power off sequence, an edge

switch or director configuration may be reset to factory default settings. This will

be evident when the HAFM application is unable to communicate with the edge

switch or director after being powered on. This condition occurs because the IP

address assigned to the edge switch or director has been reset to the factory default

value (10.1.1.10).

Workaround

Should this condition occur, the configuration of the edge switch or director must

be restored, and the IP address must be restored. Also, all licensed features will

need to be reactivated by entering the license keys again.

Erroneous Error Message When No Firmware File Selected

During a firmware upgrade, if the Download firmware file from field is left

blank, or erroneous text is entered in the field, the following error message

displays when you click Send and Load Firmware:

System File Error Firmware Successfully Loaded

Although the error message indicates that the firmware has been successfully

loaded, no changes were actually made to the switch or its firmware.

Workaround

Perform the firmware upgrade again, ensuring that the Download firmware from

file field contains a valid file name.

A Device Cannot Send Frames to Itself After the Active Zone Set Is

Deactivated

With the introduction of Hard Zoning in firmware 05.xx.xx, a device can no

longer send frames to itself after the active zone set (of which it is a member) is

deactivated.

Workaround

Perform a block/unblock to the port of the device experiencing this issue to cause

the device to log back in to the fabric and allow the device to send frames to itself.

Edge Switch Release Notes