AQUATECH PondMax Ultra Series Instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pompa wodna AQUATECH PondMax Ultra Series. AQUATECH PondMax Ultra Series 4 stron. Solar pump
Drukuj stronę– ulTra SErIES –
PM1600SP Solar PuMP
SOLAr MODULe
PUMP (VOLTAge)
MAxIMUM (FOUNTAIN JeT hIgh)
MAxIMUM FLOW rATe
reChArgeABLe BATTerY
DESCRIPTIONS AND FEATURES
• The solar pump is designed for fountain,
pond or water reservoir. Solar panel powers
the pump and charges the battery by
converting sunlight into electricity;
• This solar pump can be used almost any
time: strong sunlight, weak sunlight or
cloudy weather.
PM1600SP
16W (2x 8W SOLAr PANeL)
12 - 18V DC BrUShLeSS PUMP
2 MeTerS
1600 L/h
Lead Acid 12V - 4Ah
ASSEMBLY
• Unpack all components carefully.
• Connect the ground stake to the rear side of
frame of the solar panel.
• Connect the two solar panels and then to
the control housing.
• Place the pump underwater and make sure
that, it is fully immersed in water. If needed,
use the four flexible suction cups to stick to
the bottom of fountain pool.
• Connect tubing to the outlet or fountain head
of your choice.
• Connect the pump cable to the socket of the
control housing.
• The solar pump is now ready to use.
CAUTIONS
• Any altering of the product itself or changing
of the components is forbidden.
• Do not connect the pump to any AC
voltage power, it is intended ONLY for DC
Voltage power.
• Operate in freshwater only
o
(never above 35
C).
• Do not drop or impact the solar panel.
• Do not let the pump run dry.
OPERATING INSTRUCTIONS
Once installed, allow the solar pump to charge
at least eight hours in direct sunlight in order to
fully charge the Battery.
Test The Control System: press the "on/off"
button, the "solar powered" indicator light is
on; push the "Mode" button repeatedly, the
indicator light will cycle through the "solar
powered", "Battery powered" and "Charging"
positions; push "ON/OFF" button again, the
indicator light will be turn off.
Mode of "Charging": If you would like to
charge the battery quickly, switch to the Mode
"charging", the system will charge all energy
from sunlight to the battery without running the
pump. We recommend you turn to "Charging"
mode under direct sunlight for at least 8
hours when you first time use it. We have an
overcharge protection design in the system. It
will extend the life span of the battery.
Day Mode: Press the "on" button, the first
indicator light, "solar powered" will illuminate;
The pump operates in direct sunlight only, any
surplus power is used to charge the battery. The
performance of the pump with vary according
to sunlight conditions.
Night Mode: Press the "Mode" button to
"Battery powered", the second indicator light
will blink, the pump will run for 2 hours only
using battery power.
The default "battery powered" cycle time is
24hours. The pump will turn on automatically
same time the next day.
Press the "Cycle" button if you wish the
pump to operate for 2 hours once only, push
"cycle" button and the second indicator light
will illuminate.
Adjustable Flow Control: water flow is
controlled by a variable speed valve, you
can only adjust the water flow in the Night
(battery) mode. (Note: greater water flow
means more energy is consumed, therefore
shorter operating time)
Low battery Function: the system is designed
with battery over discharge protection. When
battery voltage lowers than design, the 4th
indicant light will blink. Allow the system
recharges the battery for at least 4 hours in
direct sunlight.